Anti-Fox No-Dig Skirt for Pens & Runs – Large
Large Anti-Fox No-Dig Skirt for Protection Pens and Runs.
IF ORDERING THE SKIRT FOR A NON-FLYTE SO FANCY RUN, PLEASE STATE SIZE OF YOUR RUN IN THE BOX BELOW - LENGTH x WIDTH - in centimetres, please.
The Large No-Dig Skirt is suitable for Flyte so Fancy Protection Pen sizes 9ft x 18ft, 9ft x 21ft and 9ft x 24ft as well as larger units like the Flyte Aviary Grand.
For you own non-Flyte so Fancy Chicken Run, this size will suit runs with a total perimeter measurement between 49ft to 66ft (14.7m to 20m). Just give us the dimensions of your run, length x width, in the text box below and we will cut 4 strips to suit that size.
Anti-Fox No-Dig Skirt for Chicken Runs - Large size for Pens with total perimeter between 14.7m and 20m. (if perimeter longer than 20m please call or email for a quote).
The Large size No-Dig Skirt is suitable for Flyte so Fancy Protection Pen sizes 9ft x 18ft, 9ft x 21ft and 9ft x 24ft as well as larger units like the Flyte Aviary Grand as well as the Arched Coops and Houses.
For you own custom Chicken Run, this size will suit runs with a total perimeter measurement between 49ft to 66ft (14.7m to 20m).
Although it would be rare that a fox would dig under the run without giving up or being disturbed unless there are easy gaps where the run meets the ground; there are the occasions when you may be away for the weekend, or on holiday and friends are in charge.
This is an inexpensive way to give you the reassurance that the hens will be safe. The fox will instinctively want to dig right next to the base of the run and would be unlikely to attempt to dig from ten inches away.
A simple solution to prevent Foxes and Badgers from digging under your Poultry Run. Four 10 inch wide strips of 2in x 2in strong 16g weldmesh are ready to lay on the ground under the edges of your run and held in place with 25cm galvanised pegs (approx 30 supplied). More Galvanised Pegs are available if needed.
Simply place the 10 inch wide strips of weldmesh on the ground where your run will sit and peg in place. The mesh should be positioned so that the edge of the mesh is held just under the base of the run and then pegged down to hold it in place.